Fluke 789 Process Meter

Fluke 789 Process Meter

The Fluke 787 was the first tool to combine a DMM and a loop calibrator to give process technicians double the power in one tool. Now it’s even better, the range is extended with the new Fluke 789 – the ultimate loop calibration multimeter. The Fluke 789 has a 24-Volt loop supply reducing the need for taking a separate power supply when doing offline transmitter testing. And with its built-in, selectable 250-Ohm Hart® resistor, it also eliminates the need to carry a separate resistor with you. Now process technicians can do a lot more while carrying a lot less.

• 24 V Loop power supply
• Very large dual display
• Enhanced backlight with 2 brightness settings
• 1200 Ohm drive capability on mA source
• HART mode setting with loop power and a built-in 250 ohm resistor
• 0% and 100 % buttons to toggle between 4 and 20 mA sourcing for a quick span check
• Externally accessible fuses for easy replacement
• Infrared-port to process data in FlukeView Forms (V2.1) software

Safety Conformance : Meets 1000 Volt EN61010-1 CAT III standards and 600 Volt EN61010-1 CAT IV standards.

Technical Specification :